Valves

Our industrial dispensing valves deliver a high accuracy of control for your precision dispensing of various materials.  These dispensing valves are specifically designed to handle a wide variety of dispensing materials. Some of the more popular materials include CA’s, RTV’s, flux, anaerobics, and silicone polymers. They are used in conjunction with our Shot Meter digital dispenser. 

 

Diaphragm Valve

Diaphragm Valve

The diaphragm valve is designed to dispense low to medium viscosity materials and is excellent for cyanoacrylates, anaerobics, UV-curing adhesives and MEK. The Shot Meter can control the valve opening and the valve's internal spring provides a clean shut off of material. The length of this unit is 3.1" (78.74 mm) and the diameter is 0.936" (23.77 mm).

Needle Valve

Needle Valve

The needle valve is excellent for a wide range of shot sizes and materials up to 100,000 cP (centipoise). It can be operated with the JGD500T using the internal spring to close it for low or medium viscosity materials like adhesives, epoxies, silicones, inks, and lubricants. For higher viscosity materials, the Shot Meter uses air to open and close the valve. The length of this unit is 4.5" (114.3 mm) and the diameter is 1.0” (25.4 mm).

Spool Valve

Spool Valve

The spool valve is designed for high pressure applications and high viscosity materials up to 300,000 cP. It is spring-closed for low to medium viscosity materials, using the Shot Meter controller. The rear action closing of the valve creates a pull-back action that prevents dripping. Suggested materials are RTVs, silicones, greases, and solder mask. The length of this unit is 4.7" (119.4 mm) and the diameter is 1.5” (38.1 mm).

Tip Caps

Spray Valve

The spray valve is pneumatically actuated and uses air pressure to dispense low to medium viscosity materials, generally up to 1000 cP. Air pressure supplied to the air cap provides atomization and can be controlled by the Shot Meter to initiate just before material is dispensed. Spray output can be varied by the fine adjustment knob controlling needle stroke distance. Suggested materials include lubricants, solvents, inks, and conformal coatings. The length of this unit is 4.2" (106.7 mm) and the diameter is 1.0” (38.1 mm).

Handheld Pinchtube Wand

Handheld Pinchtube Wand

This manual dispensing wand has a flexible silicone pinch tube and is excellent for solder masks and other flowable materials that require 50 psi or less to dispense. The pinch tube is easily replaced, therefore making clean up easy and quick. The front of the wand has a Luer Lock female fitting, allowing use of any size dispensing tip. The length of this unit is 6.73" (170.9 mm) and the diameter is 0.63” (16 mm).

Vacuum Pickup Wand

Vacuum Pickup Wand

This advanced vacuum pick-up wand has a venturi built into the handle and connects directly to an air source like the Shot Meter. It provides whisper-quiet operation and allows you to pick up components quickly. Two different angled tips and three suction cups are included. The length of this unit is 5.25" (133.4 mm) and the diameter is 0.48” (12.19 mm).